Photos for Bluewater Custom Woodworking & Design

Reviews for Bluewater Custom Woodworking & Design

Add your comment
  • February 2024

    From Paul Vail: I wanted a ramp to go up 3 ft. to my porch. I thought of aluminum catwalk but it would cost over $4000. For half that, Bluewater Fabricating made me a fiberglass, 3x16 ft. ramp with 1in. holes and 1/4in. ribs,11/4in.deep with 1/4x5in. aluminum side rails. The snow goes right through and the ribs are so grippy there is no slippage even if icy! Zero maintainance. no rust, 100% satisfaction. Most friends walk up the ramp instead of the stairs. Side rails bolted on with STAINLES STEEL bolts keep wheeled vehicles from running off and I LOVE it!

  • December 2022

    Thanks to Bluewater Custom Fabricating I should be able to get many years out of my truck. I had extensive rust damage to my frame beside the gas tank. When I drove out to have them look at it, they already had a vehicle on their hoist so Kyle made a call, hopped into my truck and we drove out to a shop with an open hoist bay - amazing customer service, from an honest, hardworking team of professionals.

  • August 2022

    This main floor facelift turned out perfect! . This project started with just removing plaster crown molding and adding some new pot lights by @tibelectric . Updated the floor and trim….. then we built this fireplace. Gas fireplace, with shiplap surround and custom handmade mantle. (No that’s not a beam, @theangrycarpenter built that with barn board, and distressed it by hand). After some fine tuning to assure inspectors we were meeting code we had to remake the bottom trim pc on the fireplace. Huge shout out to @bluewatercustomfab for crushing this for us and turning it out flawlessly over night. Very impressed with these guys and their crew!! Thanks again!! And... read full review

  • Bluewater Custom Woodworking & Design

    1240 Willa Dr, Sarnia

    Directions Call Suggest an Edit